UtterAccess.com
X   Site Message
(Message will auto close in 2 seconds)

Welcome Guest ( Log In | Register )

> Mask For Emails, Office 2007    
 
   
cwac60
post Apr 11 2012, 10:28 PM
Post #1

UtterAccess Veteran
Posts: 310
From: Queensland Australia
Hi Colleagues

One web site suggested the appropriate mask for an eMail was &aaaaaaaaaa\@aaaaaaaaaa\.aaa - allowing
up to 10 characters both sides of @.
However there may also be instances of another section of domain e.g. xxx@com.au - which is NOT mandatory.
How do you setup a mask to allow for the .au section but not reject if it does not exist?

Regards
cwac60
Go to the top of the page
 
+

Posts in this topic
- cwac60   Mask For Emails   Apr 11 2012, 10:28 PM
- - arnelgp   I dont use mask (were talking TextBox right), I on...   Apr 12 2012, 05:26 AM
- - Alan_G   Hi Have a look at this previous post for a couple...   Apr 12 2012, 06:24 AM

« Next Oldest · Access Forms · Next Newest »
 

Thank you for your support! Reply to this topicStart new topic

Jump To Forum:
 

Display Mode: Switch to: Standard · Switch to: Linear+ · Outline

Track this topic · Email this topic · Print this topic · Subscribe to this forum

RSS Go to Top  ·  Lo-Fi Version Time is now: 23rd May 2013 - 09:33 AM