UtterAccess.com
X   Site Message
(Message will auto close in 2 seconds)

Welcome Guest ( Log In | Register )

> Pre-Load Data    
 
   
mcrazyinsano
post Nov 27 2008, 09:26 PM
Post #1

UtterAccess Addict
Posts: 204
Any way to set it up so when a certain form opens or when the DB opens it pre-loads all data into memory to allow for faster searching?
thank you
Go to the top of the page
 
+
 
 Start new topic
Replies
theDBguy
post Nov 27 2008, 11:20 PM
Post #2

Access Wiki and Forums Moderator
Posts: 47,940
From: SoCal, USA
Haven't tried it before, but I guess you're talking about disconnected recordsets.

Try doing a search on "disconnected recordsets" and see if that will work for you.

Hope that helps...
Go to the top of the page
 
+

Posts in this topic
- mcrazyinsano   Pre-Load Data   Nov 27 2008, 09:26 PM
- - theDBguy   Re: Pre-Load Data   Nov 27 2008, 11:20 PM

« Next Oldest · Access Forms · Next Newest »
 

Thank you for your support! Reply to this topicStart new topic

Jump To Forum:
 

Display Mode: Switch to: Standard · Switch to: Linear+ · Outline

Track this topic · Email this topic · Print this topic · Subscribe to this forum

RSS Go to Top  ·  Lo-Fi Version Time is now: 21st May 2013 - 04:12 AM