All's been going good with the development. I'm having a bit of trouble figuring out the problem with my mapquest buttons though.
This first url is the url created by mapquest when i type the address into directions.
This is the url generated by my buttons for the same address.
I noticed one problem is the =Get+Map at the end isnt needed for directions but it shouldn't cause the problem i'm getting either. In both urls the correct address 7329 pinehurst drive, spring hill, fl, 34606 are present *the destination*
The starting point works on my buttons but when I click to get map for my button on that address it goes to "Spring Hill, FL 34606, US " with no actual address but it ends at Thornberry road. Thornberry is actually the address i used when I first got the code and cut it per my fields, "street, city, st and zip".
The URL i used to 'cut' is as follows:
I cut the part in BOLD and put as 'set' for the starting point and than I have my street, city, state, and zip set to "=&2a" "=&2c" "=&2s" and "=&2z". It seems like it 'should' work from the URL generated but it doesnt and I cannot figure out how the generated URL references the Thornberry address.
If anybody is familiar with doing this and can offer some suggestion it would be great. I've already searched through prior topics, thats actually where i got most of the cd and the module i'm using. The 'map' function I have works flawlesy for the clients address, just having issues with directions.
Thanks in advance!